Technical information

AN2317/D
26 Low-Cost Programming and Debugging Options for M68HC08 MCUs
The PROG08SZ Attempting to contact target and pass security… window
appears. (Refer to Figure 11)
7. Select the appropriate class in Target Hardware Type (Class III for
low-cost MON08 circuit from Figure 7) and baud rate.
8. Click Contact target with these settings…
9. Follow the Power Cycle dialog instructions.
10. Click Yes in Confirm window. (Figure 17)
11. Click Yes in Erase and Program FLASH window. (Figure 18)
12. Follow the subsequent Power Cycle dialog instructions as the scripted
procedure automatically establishes communications, erases the
FLASH if necessary, and programs the FLASH.
Figure 17. Confirm Window
Figure 18. Erase and Program FLASH Window
At this point, the FLASH memory is programmed and ready for debug. The
True-Time Simulator & Real-Time Debugger integrates the debugger tools
from P&E Microcomputer Systems in this example. The windows look slightly
different between the ICD08SZ and True-Time tools (compare Figure 13 with
Figure 15), but the same basic debugger (ICD08SZ) drives both.
Freescale Semiconductor, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc
.
..