Technical information

AN2317/D
20 Low-Cost Programming and Debugging Options for M68HC08 MCUs
Here are the main steps in programming the FLASH with PROG08SZ in normal
monitor mode:
1. Launch P&E’s WinIDE from the ICS08 software.
2. Open desired file or develop new code.
3. Assemble the file.
4. Attach MON08 pod between PC and target.
5. Click on programmer icon.
6. From Target Hardware Type, select Class III (see Figure 10).
7. Select the PC port and the appropriate baud rate (see Figure 11).
8. From Target MCU Security Bytes, select appropriate security codes or
check the IGNORE security failure box.
9. Click Contact target with these settings…
10. Follow the instructions in the Power Cycle dialog window.
11. Select appropriate algorithm for the part (908_gt16_highspeed.08p in
Figure 12).
12. Double-click on Erase module (see Figure 12). (Flash cannot be
programmed unless first erased.)
13. Double-click on Specify S record and select file.
14. Double-click on Program module.
15. Double-click on Verify module. (Optional)
16. Double-click on Quit to exit the programmer.
At this point the FLASH memory on the MCU is programmed and ready for
in-circuit debugging.
Freescale Semiconductor, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc
.
..