Technical information

AN2317/D
18 Low-Cost Programming and Debugging Options for M68HC08 MCUs
Low-Cost MON08 Software
Free or low-cost software options for programming and debugging M68HC908
MCUs are available from P&E Microcomputer Systems (www.pemicro.com),
Metrowerks (www.metrowerks.com), and ImageCraft
(www.imagecraft.com/software/). P&E’s ICS08 interface software packages
are available at no charge for individual use by registering at their web site.
Metrowerk’s CodeWarrior Development Studio for 68HC08, Special Edition, is
available at no charge from the Motorola MCU Web site
(www.motorola.com/semiconductors/mcu). You must register for the license
key for this software. ImageCraft’s low-cost ICC08 compiler works with the
NoICE debugger. P&E also bundles programming software in their
MON08-Cyclone and MON08-Multilink tools.
P&E Microcomputer
Systems
P&E’s ICS08 software packages contain the WinIDE integrated development
environment, which pulls together an assembler, in-circuit simulator, memory
programmer, and in-circuit debugger. The programmer and debugger work
with any MON08 hardware interface, as shown in the target hardware type
menu in Figure 10. Class III is used with the MON08 interfaces in Figure 4,
Figure 5, and Figure 7, above. Classes V and VII are used with the Cyclone
and Multilink pods, respectively.
The following examples illustrate how to program and debug an
M68HC908GT16 MCU with P&E’s PROG08SZ and ICD08SZ tools. The
MON08 pod in this example is a custom version of the circuit shown in
Figure 4.
Figure 10. Hardware Selection in P&E PROG08SZ
Freescale Semiconductor, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc
.
..