Personal Computer - Word Processor User Manual

Hardware Design
High-Voltage Hardware Set Components
DRM028 — Rev 0 Designer Reference Manual
MOTOROLA Hardware Design 69
250 ns for digital signals, and 2 µs for analog signals. Grounds are
separated by the optocouplers’ galvanic isolation barrier.
Both input and output connections are made via 40-pin ribbon cable
connectors. The pin assignments for both connectors are the same. For
example, signal PWM_AT appears on pin 1 of the input connector and
also on pin 1 of the output connector. In addition to the usual motor
control signals, an MC68HC705JJ7CDW serves as a serial link, which
allows controller software to identify the power board.
Power requirements for controller side circuitry are met with a single
external 12-Vdc power supply. Power for power stage side circuitry is
supplied from the power stage through the 40-pin output connector.
4.4.2.1 Electrical Characteristics of the Optoisolation Board
The electrical characteristics in Table 4-3 apply to operation at 25°C,
and a 12-Vdc power supply voltage.
Table 4-3. Electrical Characteristics
Characteristic Symbol Min Typ Max Units Notes
Power Supply Voltage Vdc 10 12 30 V
Quiescent Current
I
CC
70
(1)
200
(2)
500
(3)
mA dc/dc converter
Min Logic 1 Input Voltage
V
IH
2.0 — — V HCT logic
Max Logic 0 Input Voltage
V
IL
— — 0.8 V HCT logic
Analog Input Range
V
In
0—3.3V
Input Resistance
R
In
—10—kΩ
Analog Output Range
V
Out
0—3.3V
Digital Delay Time
t
DDLY
—0.25— µs
Analog Delay Time
t
ADLY
—2—µs
1. Power supply powers optoisolation board only.
2. Current consumption of optoisolation board plus DSP EMV board (powered from this power supply)
3. Maximum current handled by dc/dc converters
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...