Barcode Reader User Manual

5 - 2 Symbol LS3578 Product Reference Guide
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code under Beeper Tone on page 5-5. The scanner issues a fast warble
beep and the LED turns green, indicating a successful parameter entry.
Other parameters, such as Laser On Time or Data Transmission Formats, require scanning several bar codes.
See the parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
User Preferences Default Parameters
Table 5-1 lists the defaults for user preference parameters. To change any option, scan the appropriate bar code(s)
provided in User Preferences on page 5-4.
NOTE See Appendix A, Standard Default Parameters for all user preference, host, symbology, and
miscellaneous default parameters..
Table 5-1 User Preferences Default Table
Parameter Default
Page
Number
User Preferences
Default Parameters Restore Defaults 5-4
Beeper Tone Medium 5-5
Beeper Volume High 5-6
Laser On Time 3.0 sec 5-7
Beep After Good Decode Enable 5-7
Trigger Mode Level 5-8
Aim Duration 0.0 sec 5-9
Beep on Insertion Enable 5-9
Time Delay to Reduced Power Mode 1 Second 5-10
Transmit Code ID Character None 5-11
Scan Angle Normal Angle 5-11
Prefix Value 7013 <CR><LF> 5-12
Suffix Value 7013 <CR><LF> 5-12