Barcode Reader User Manual

12 - 24 Symbol LS3578 Product Reference Guide
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 12-1 Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character
Scan the Move Cursor To Character on page 12-25, then any
printable ASCII character from the Alphanumeric Keyboard on page
12-86. When this is used, the cursor moves to the position after the
matching character. If the character is not there, the rule fails and
ADF tries the next rule.
12-25
Move Cursor to Start of Data
Scan this bar code to move cursor to the beginning of the data. 12-25
Move Cursor Past a Character
This parameter moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the Move Cursor Past
Character on page 12-25, then select a character from the
Alphanumeric Keyboard on page 12-86. If the character is not there,
the cursor does not move (i.e., has no effect).
12-25
Skip Ahead “N” Characters
Scan one of these bar codes to select the number of positions ahead
to move the cursor.
12-26
Skip Back “N” Characters
Scan one of these bar codes to select the number of positions back
to move the cursor.
12-28
Send Preset Value
Send Values 1 through 6 by scanning the appropriate bar code.
These values must be set using the prefix/suffix values in Table 7-4
on page 7-20.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
12-28