Specifications

3-5
Maintenance and Specifications
What If...
Nothing happens when you follow the operating instructions?
You Should
!
Check the system power; is there a battery in the battery box?
!
Be sure the scanner is programmed for the terminal in use.
!
Make sure the scanner is programmed to read the type of bar code you are scanning.
!
Check for loose cable connections.
!
Check the symbol to make sure it is not defaced.
!
Try scanning test symbols of the same code type.
!
Be sure you are within the proper scanning range.
Symbol is decoded, but not transmitted to the host terminal?
You Should
!
Be sure the proper host type is selected (See Chapter 4).
Scanned data is incorrectly displayed on the terminal?
You Should
!
Make sure the system is programmed for the correct keyboard type.
!
Make sure the CAPS LOCK key is off.
!
Be sure the proper host is selected.
!
Be sure editing options (e.g., UPC-E to UPC-A Conversion) are properly
programmed.
If after performing these checks the symbol still does not scan, contact your distributor or call
the Symbol Support Center. See page viii for the telephone number.