User`s guide

48 Advanced Settings
13. Advanced Settings
13.1 Set the Dial Mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press P and , to select SETUP BS .
2. Press P to select DIAL MODE .
3. Press P and , to select TONE or PULSE .
4. Press P to save.
NOTE
If pulse mode is selected, press
* to switch from
pulse to tone dialing temporarily when dialing out. After
the call is ended, the dial mode will change back to
pulse.
13.2 Set the Flash Time
The default flash time is 600MS . It is unlikely that you
should need to change this setting unless advised to do
so.
1. Press P and , to select SETUP BS .
2. Press P and , to select FLASH TIME .
3. Press P and , to the flash time you want. (8
options are available:
90 , 100 , 110 , 250 , 300 , 400 , 600
and
700MS )
4. Press P to save.
13.3 Set the Area Code
1. Press P and , to select SETUP BS .
2. Press P and , to select AREA CODE .
3. Press P and enter the area code.
4. Press P to save.
13.4 Reset All Settings
All personalized settings will be reset to default.
Phonebook entries, calls list and redial list will remain
unchanged.
1. Press P and , to select RESET SETTINGS .
2. Press P and , to select ALL SETTINGS .
3. Press P to select YES .
4. Press P to reset all settings to default.