Specifications

Technological Advancements
Introduction
August 08, 2000 68P81095E55-E 1-13
OMC
Performance
Management
Phase 1
(Operations)
None S1000 OMC is no longer supported None
This improves reporting and prioritization of alarms and messages
for E3000/U2 and E3500/U60 OMC-R platforms. The OMC-R
will poll for missing statistics until they are received. Network
elements stagger the delivery of statistics to reduce the load on the
CPU.
Isolated Site
Operation for
Multiple OMCs
None None
Isolated Site operation is now available for networked OMCs
BSC
XCDR Voice
Processor
Recovery
None None
XCDR processor can be software reloaded if it is in standby, reset,
reloaded, and re-initialized status.
Enhanced BSC
Event Reporting
(OMC/ BSC)
Operations
None None
Provides a smart tool to assist in fault isolation. New status
information is acquired, and root causes are displayed.
Caution
This is not backwardly compatible with SR 8.0. BSC elements
must be upgraded at the same time.
BSC system
Audit Trail
(OMC & BSC)
None None
Helps identify BSC under-utilization or over-utilization with
proactive CPU utilization reporting. This reports average CPU
utilization between reporting periods for each control processor.
New alarms are available and thresholds are configurable.
BSC Time
Synchronization
None None
To reduce BSC - OMC-R timing differences, the BSC will not poll
the OMC for timing information. This may be enabled or disabled
at the OMC.
Data
Packet Data
Compression
Capacity
Yes Requires new MDG None
SR 9.1 provides Packet Data compression. Packet data may be
compressed for transmission. This is provisioned in the iHLR
Enhanced MDG
- Phase 1
New MDG 15K subscriber MDG not supported None
A new MDG increases the number of subscribers per MDG from
15,000 to 64,000. The replacement should be 1 to 1 to reduce
downtime.
Sub-
System
Enhancement Hardware
Impact
FNE Notes Subscriber
Impact