Cell Phone User Guide
Table Of Contents
- check it out
- contents
- menu map
- Use and Care
- essentials
- about this guide
- SIM card
- battery
- turn it on & off
- enable security
- make a phone call
- answer a phone call
- make a private call
- answer a private call
- store a phone number or private ID
- call a stored phone number or private ID
- find your phone number and private ID
- text messages
- manage memory
- using your handset as a modem
- main attractions
- basics
- calls
- customize
- other features
- Safety and General Information
- Service & Repairs
- Specific Absorption Rate Data
- Limited Warranty Motorola Communications Products (International)
- Hearing Aid Compatibility
- Information From the World Health Organization
- Patent and Trademark Information
- Privacy and Data Security
- Smart Practices While Driving
84
Export Law
Specific Absorption Rate Data
ALL MODELS WITH FCC ID AZ489FT5844 MEET THE
GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO
WAVES.
Your wireless phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These limits
are part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons, regardless of
age and health.
The exposure standard for wireless mobile phones employs a unit
of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg.
1
Tests for SAR are
conducted using standard operating positions reviewed by the FCC
with the phone transmitting at its highest certified power level in
all tested frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels
so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station antenna, the
lower the power output.
Before a phone model is available for sale to the public, it must be
tested and certified to the FCC that is does not exceed the limit
established by the government-adopted requirement for safe
exposure. The tests are performed in positions and locations (e.g.,
at the ear and worn on the body) as required by the FCC for each
model. The highest SAR value for this model phone when tested
for use at the ear is 1.05 W/kg and when tested on the body, as
described in this user guide, is 1.15 W/kg during packet data
transmission. (Body-worn measurements differ among phone
models, depending upon available accessories and FCC
requirements.)
2
While there may be differences between the SAR levels of various
phones and at various positions, they all meet the government
requirement for safe exposure. Please note that improvements to
this product model could cause differences in the SAR value for
later products; in all cases, products are designed to be within the
guidelines.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications Industry Association
(CTIA) web-site at http://www.ctia.org
or the Canadian Wireless
Telecommunications Association (CWTA) Web site:
http://www.cwta.ca