User Guide

64
English
SCAN
• The display shows G.
• The LED indicator blinks green; it stops
blinking when your radio switches to an
active talkgroup.
Note: If you enter Menu mode while your radio
is scanning, scanning stops. The radio
resumes scanning when you exit Menu
mode.
To start All Group Scan, press the
preprogrammed All Group Scan button (see
page 16) once.
To stop All Group Scan, press the
preprogrammed All Group Scan button again.
–or–
To start or stop All Group Scan Operation
through the menu:
SYSTEM SCAN G
(LTR TRUNKED AND CONVENTIONAL
OPERATION ONLY)
System Scan scans Trunked talkgroups and
Conventional channels between LTR and
Conventional zones, as programmed by your
dealer. Up to 16 different talkgroups or
Conventional channels can be programmed
into each Scan list. You can edit these lists
through your radio’s menu (see page 66).
When System Scan is enabled:
• The display shows G.
• The LED indicator blinks green during
System Scan operation; it stops blinking
when your radio switches to an active
talkgroup or channel.
1 ) to enter Menu mode.
2 + or ? until
3 ) to select
You see the current scan status.
All Group Scan
All Group Scan
4 + or ? until
–or–
5 ) to confirm your selection.
All Group On?
All Group Off?