User Guide
Table Of Contents
- CONTENTS
 - Safety
 - Introduction
 - Radio Overview
 - Getting Started
- Battery Information
 - Accessory Information
 - Turning your Radio On or Off
 - Adjusting the Volume
 - Selecting a Trunked Zone and Talkgroup
 - Sending a Trunked Call
 - Selecting a Conventional Zone and Channel
 - Sending a Conventional Call
 - Receiving a Trunked or Conventional Call
 - Repeater or Talkaround J Mode
 - Call Light
 - (Trunked Operation Only)
 - Home Channel Revert
 
 - PassPort Trunking
 - PassPort Signaling
 - Radio Calls
 - Scan
- Talkback
 - PassPort Primary Auto Group Scan
 - (PassPort Trunked Operation Only)
 - PassPort Group Scan G
 - (PassPort Trunked Operation Only)
 - Auto Group Scan G
 - (LTR Trunked Operation Only)
 - All Group Scan G
 - (LTR Trunked Operation Only)
 - System Scan G
 - (LTR Trunked and conventional Operation Only)
 - Deleting a Nuisance Channel or Talkgroup
 - Editing a Scan List
 - View a Scan List
 - Adding or Deleting Talkgroups or Channels in a Scan List
 - Prioritizing a Talkgroup or Channel in a Scan List
 
 - Phone
 - Voice Storage
 - Audio/Tone Settings
 - Utilities
 - Warranty
 - Accessories
 - 88C42-E_french.pdf
- Table des Matiéres
 - Sécurité
 - Introduction
 - Aperçu de la radio
 - Mise en route
- Informations sur la pile
 - Informations sur les accessoires
 - Activation ou désactivation de votre radio
 - Réglage du volume
 - Sélection d'une zone ou d'un groupe de conversation partagé
 - Envoi d’un appel partagé
 - Sélection d'une zone ou d'un canal conventionnel
 - Envoi d’un appel conventionnel
 - Réception d’un appel partagé ou d'un appel conventionnel
 - Mode Relais ou Intercommunication J
 - Voyant d’appel
 - (Opération partagée seulement)
 - Retour au canal d'origine
 
 - Signalement PassPort
 - Commutation PassPort
 - Appels radio
- Appel sélectif
 - Réception d’un Appel sélectif F
 - Envoi d’un message Avis d’appel
 - Réception d’un Avis d’appelF
 - Verific. Radio
 - Envoi d’un Message d’état
 - Envoi d’un message
 - Réception d’un message
 - Envoi d'un signal d'urgence E
 - (Modes conventionnel et LTR uniquement)
 - Modification d’un répertoire de radios K
 - Identification des noms et des tonalités d’appel
 
 - Balayage
- Réponse
 - Balayage automatique des groupes principaux PassPort
 - (Opération partagée PassPort seulement)
 - Balayage de groupes PassPort G
 - (Opération partagée PassPort seulement)
 - Balayage automatique de groupes G
 - (Opérations partagées LTR seulement)
 - Balayage automatique de tous les groupes G
 - (Opérations partagées LTR seulement)
 - Balayage du système G
 - (opération partagée LTR et conventionnelle seulement)
 - Suppression d’un canal ou d’un groupe de conversation importun
 - Modification d’une liste de balayage
 - Afficher une liste de balayage
 - Ajout ou suppression de groupes de conversation ou de canaux dans une liste de balayage
 - Classer par ordre de priorité un groupe ou un canal dans une liste de balayage
 
 - Téléphone
 - Messagerie vocale
 - Paramètres audio/ tonalité
 - Fonctions auxiliaires
 - Garantie
 - Accessoires
 
 

37
English
PASSPORT 
TRUNKING
To Cancel a Roam Request:
HOME SITE REVERT
This feature allows you to force a HT1250•LS+
radio to search for its home site and register on 
it while the radio is currently registered on an 
affiliated site.
A bad key chirp may sound and you 
see:
This can occur under the following 
circumstances:
• When registration to a site with a higher 
RSSI than your current site is unavailable. 
• When the preprogrammed button is 
pressed before your radio has collected its 
“neighbor list”. A “neighbor list” is a list of 
frequencies from adjoining sites within the 
PassPort system that are used during the 
roam process.
• When your radio is programmed for a 
single site system (Home Site only). 
In these cases, wait a few seconds and try 
again.
4 The selected 
PassPort talkgroup 
alias appears and 
remains on the 
display.
Roam Not Avail
TLKGRP ALIAS
Press and hold the preprogrammed Roam 
Request button (see page 19) again.
You see:
Note: Your radio then attempts to return to 
the previously registered site. 
1
Press the preprogrammed Home Site Revert 
button (see page 19).
2
When the radio is 
searching for a new 
site or attempting 
registration to a site, 
you see:
Cncl Roam Req
SEARCHING










