Projector User Manual

GT10/GT30 5.2 Entering Configuration Settings with GTWIN

· Bit area ––– This specifies the type of device that reads and writes backlight

control and other bit information, and the initial address.

The type of device and addresses can be set by clicking on the

buttons for the

various items.

Device settings dialog box

Clicking on the button displays a pull–down

menu. Select the device for which settings are

to be entered, and use the ten–keys to enter

addresses.

The button functions as a backspace

key when entering addresses.

The button acts as a Clear key.

REFERENCE

For detailed information on the basic communication area map, see

“GT10 Basic Communication Area Map” on page 30.

EXPLANATION

Standard settings

Clicking on the button in the “GT Configuration” dialog box displays the

following message. Clicking on [OK] sets the default values (the configuration settings

entered when the unit is shipped) for all of the settings.

For information on the contents of configuration settings entered when the unit is

shipped, see “Contents of configuration settings for GT10 when shipped from the

factory” on page 26.

5.2.3 GT Configuration Settings: “Communication Parameters”

Clicking on the “Communication Parameters” tab in the “GT Configuration” dialog box

displays the following screen.