User`s manual

Using the UP/DOWN arrow keys, adjust the Transmitter Power per your User's Manual. Press
F6 again to de-key the radio, and the value will be programmed into the radio.
NOTE: For fast changes, keyin the value and press the Enter button.
BATTERY THRESHOLD ADJUSTMENT
This aligment screen adjusts the battery threshold value for NICAD and ALKALINE battery
threshold used by the radio. RX values indicate battery threshold while in receive mode, while TX
values indicate battery threshold while in transmit mode. The values determines the A/D value of
the battery line input in either transmit or receive mode, below which will register a low battery
condition for the battery type used.
PARTS REPLACEMENT
Refer to your RPG Service Manual for PARTS REPLACEMENT procedures.
Calibration is required after the following parts replacement:
Main Board
Refer to your RPG Service Manual for MAIN BOARD REPLACEMENT procedures.
Only one step (Step 2) is provided at the moment. More will be added in future as the need
arises.
REFERENCE CRYSTAL DATA
Refer to your RPG Radio Service Software User's Manual for entering the Crystal Warping Data.
The GET/SAVE functions are used to transfer codeplug data from your radio into your computer
in order for you to Change and View. GET/SAVE functions also permit you to PROGRAM
modified data back into your radio.
!!! WARNING !!!
Do NOT turn off the radio or disconnect it from the computer while attempting to PROGRAM the
codeplug. Interrupting the programming process WILL destroy the codeplug contents and
completely DISABLE the radio!
Function Key Descriptions:
F2 - The READ CODEPLUG function reads the information (data) stored in the radio codeplug
(EEPROM) and transfers it to the computer's memory.