Specifications

Group Call
• Press [9] “Contact list” should be displayed.
• Press [9] to select, the wanted location and agency alias should be
displayed.
• If the wanted location is not displayed, use the Up/Down arrows to scroll
through the addresses until the desired entry is displayed.
• The display will show “Selected” for a couple of seconds and then return to
the default menu (Channel).
• Now press Up or Down arrow until “Status” is displayed, press [9].
• Use the arrow keys to scroll through the address book. Press [9] when the
desired group or user has been found.
• The radio will display “Selected” for a few seconds and then return to the
default menu.
• To send the group call, press the Call button.
The call sequence can be heard and all radios within range and on the same channel in
the group will emit a beep to indicate to the user someone has called them. A group
call alert differs from an individual call in that it is one long tone instead of the
ringing an individual call will generate.
Pre Defined Group Call
• Press [9], “Contact list” should be displayed.
• Press [9] to select, the wanted group should be displayed (WFP etc).
• If the desired group is not displayed, use the Up/Down arrow (or rotating
knob on top) to scroll through the entries in the address book. For this type
of group calls only entries in the address book starting with a minus “-“
must be selected (“- All WFP Mobile”).
• Press [
9] to confirm selection.
• The radio will display “Selected” for a few seconds and then return to the
default menu.
• Press the Call button to send the call.
Radio Operators Training Manual Version 27/11/2007 21