Technical information

Chapter 2: Developer Board and Interfaces Description
August 31, 2009 G24/H24 - Developer’s Kit 23
To Connect to the Internal Antenna
• Connect the EXT ANT and INT ANT connectors with the additional RF cable supplied in the
Developer’s Kit (Figure 2-13).
Note: This is the Developer Board’s default configuration. The board arrives with the EXT ANT
and
INT ANT already connected.
Figure 2-13: Antenna Connectors (internal)
To Connect to an External Antenna
1. Disconnect the external RF cable from the EXT ANT connector.
2. Connect an external antenna or antenna application to the
EXT ANT connector
(Figure 2-13).
The connection cable is not included.