Technical information

Configuration
12 G24/H24 - Developer’s Kit August 31, 2009
Configuration
After performing Initial Setup (previous section), you can continue using the Developer Board
this default setup. This section describes how to change the default setup so you can use different
peripherals or change default board operation.
Alternate Power Sources
The Developer Board power can be supplied from:
• Wall mount power adapter (see “Wall Mount Adapter Operation” on page 13)
• External DC power source (see “DC Power Source Operation” on page 14)
A single power source is used for the G24/H24 and the board peripherals.
You must connect the Developer Board to a power source, and then set the power source jumper
(P204), if necessary (see “Selecting the Power Source” on page 15).
Two other jumpers (Figure 2-7) help control the power supply in the Developer Board:
• P201—Connects/disconnects the power from the Developer Board peripherals
• P200—Connects/disconnects the power from the G24/H24
Figure 2-7: Power Supply Connectors, Jumpers and Switches
Each power supply option is described in the sections that follow.