Technical information

Initial Setup

8 G24/H24 - Developer’s Kit August 31, 2009

Figure 2-2: Connecting the G24/H24

Connecting External Accessories

Replace the Developer Board cover and connect the following external connectors in the

sequence shown.

Power Supply

Caution: Before connecting the power supply, make sure that the Developer Board On/Off

switch (located in the rear of the board, as shown in Figure 2-3, on page 9) is in the

OFF position.

Caution: When using the Wall adapter, make sure to insert it into the Power Adapter

Connector (J210) and not to the Mini-AB USB connector (J380), as shown in

Figure 2-3, on page 9.

To Connect the Power Supply

1. Connect the supplied Wall adapter to the Wall Adapter Connector (J230) (Figure 2-3).

MMCX

Connector

Internal

RF Cable

External

RF Cable

External

Antenna

Connector

Internal

Antenna

Connector

G24

Screws