Ethernet Broadband Router User Guide

CONFIGURATION SECTION 3
SECTION 3, CONFIGURATION 3-19
Networking - Routing
You can define up to 20 static routes that specify the Network
Destination, Subnet Mask, Gateway, Interface, and Metric. You
configure the Network Routing Table here.
RIP (Routing Information Protocol) versions 1 and 2 are routing
protocols that are part of the TCP/IP protocol standard. RIP
dynamically determines a route based on the smallest hop count
between source and destination. To access the screen, click
NETWORKING > ROUTING. Click APPLY to save your settings or
CANCEL to cancel changes.
Field Description
RIPv1 Receive Enables or disables RIPv1 Receive.
The default is disabled.
RIPv2 Receive Enables or disables RIPv2 Receive.
The default is disabled.
RIPv1 Transmit Enables or disables RIPv1 Transmit.
The default is disabled.