user manual

" DRIVE

TO 2.4 V

' " ' CLK

D°TPUTS(2):L~ ' " VAL'O " '~2"0V 2.OV .'VA"0'

I 00TP,T° 0.aV~V_/_/-'I~_~V OUTPOTo+,

..... , ........ To 2:iv "TA--Y- 2.0 v VAL, O 28 v-&V77

;RIVE IN 0T 08V

T00,v t._c4._0_, t

. INPUTS(4) CLK "-~2E08; :NApL~DT :.::~ T02.4V

ALL

SIGNALS

(S)

. --~-- 2.0 V

.~- 0.8 V

NOTES:

1 - This out[)ut timing is applicable to all parameters specified relative to the rising edge of the clock

2"-This output'timing is applicable to all parameiers specified relative to" the fallingecIge ofthe cl()ck "

3 - This input timing is applicable to all parameters specified relative to the rising edge of the Clock

4 - This

input

timing is applicable to all

parameters specified

relative to the

falling

edge of the clock

5 - This timing is applicable to all parameters specified relative to the assertion/negation of another signal

LEGEND:

A - Maximum output delay specification

B - Minimum output hold time

C - Minimum input setup time specification

D - Minimum input hold time specification

E - Signal valid to signal valid specification (maximum or minimum)

F - Signal valid to signal invalid specification (maximum or minimum)

Figure 1. Drive Levels and Test Points for AC Specifications

4 MC68030 ELECTRICAL-SPECIFICATIONS MOTOROLA