User guide

iControl
Release Notes
3
In order to be able to modify the Configuration Spreadsheet used to define the iControl
monitoring layout, you will need a PC with Microsoft® Excel®.
Installation and Network Requirements
Users can access the iControl Application Server from a client PC using a standard Web
browser (Microsoft Internet Explorer or Mozilla Firefox). When a client logs in and launches an
iControl module, the software is automatically downloaded from the Application Server.
Consequently, no other application software is needed, which greatly simplifies installation
and system maintenance.
It is recommended that the iControl Application Server (as well as the associated equipment it
controls) be installed on a dedicated LAN, using the existing security infrastructure. A qualified
system administrator should verify that the setup follows your organization’s security
standards.
Software Component Compatibility
iControl version 4.40 is compatible with the following Miranda software components:
• iControl Router Manager and Router Service version 3.00 and later
• RCP-100 Remote Control Panel firmware version 1.80 and later
• RCP-200 Remote Control Panel firmware version 1.1.0 and later (version 1.3.0 or later
recommended)
• iC Web version 3.00 and later
• Kaleido-K2 version 5.30 and later (refer to the Kaleido-K2 Release Notes)
• Kaleido-X version 2.0 and later
• Kaleido-IP version 6.00 and later (version 6.50 recommended for best performance and
maximum functionality)
• Densité CPU-ETH controller version 3.00 and later
• Densité CPU-ETH2 version 1.0.5 and later (version 2.0.4 or later recommended)
• EdgeVision version 1.00 and later (version 1.20 recommended, for best performance and
maximum functionality)
• NV9000 version 6.1.0.1538 and later (version 6.2.0.1674 and later recommended for best
performance and maximum functionality)
• SEUtilities version 6.0.28 and later (version 6.2.2 build 125 and later recommended for best
performance and maximum functionality)
Documentation
The user documentation for iControl version 4.40 is available from the Documentation link on
the Application Server’s Startup page: