User guide

iControl
Release Notes
49
Imagestore
• [Ref. #35435] On the control panel for an ImageStore device, when you click one of the
Video GPI or Audio GPI buttons on the Control tab, the system activates a different virtual
GPI than was indicated.
Workaround: Map the Video GPI and Audio GPI buttons of the ImageStore control panel
to the corresponding activated GPI using the following matrix:
•
[Ref. #17022]The Bypass button in the iControl service panel for an Imagestore only allows
you to enable a bypass, not to remove it.
Imaging Series
• Using a Quartet 1 frame to house AAP-711, ADL-701, AAP-712 and AAP-702 cards could
cause iControl to mismatch slot numbers. If a card in the reference configuration is
removed, another type of card inserted and removed in the slot, and then the first card is
put back, it can re-appear in slot 2. The same cards could also cause iControl to misbehave.
Sometimes, two of the cards can disappear from iC Navigator and return after a while.
These cards consume a lot of power and the Quartet frame could encounter some
problems from time to time; it is recommended to use a Symphonie frame with this set of
cards.
• It can take up to 45 seconds to discover a Quartet 1 frame. Discovery of the Quartet 2
frame is much faster.
•
[Ref. #10199] It can happen that an Imaging communicator fails on startup when trying to
initialize its serial com port.
Workaround: Try restarting the Imaging Connection Manager for that port using
Webmin’s iControl services monitoring and configuration tool (refer to Starting & Stopping
GPI buttons on
control panel
Mapped Virtual
GPI
--- Video ---
12
23
34
45
--- Audio ---
110
211
312
413