User guide

Release Notes
iC Router Control
26
iC Router Control
• [Ref. #32092 / 28098] Evertz Quartz Type 1 ASCII Protocol: Support for viewing router error
conditions on iC Web clients.
iC Web
• [Ref. #31998] iControl Web now allows you to specify the dimensions of your desired Total
Fullscreen size (
Ctrl + F11 ). For example, if your setup has four monitors but you would like
the Total Fullscreen size to include only two of the monitors, you can do so by editing the
page properties in iC Creator.
Redundancy / Failover
• [Ref. #22047] The Automatic Failover feature now includes alarming to indicate Application
Servers’ takeover states. The relevant alarms are in the Health Monitoring folder of the
GSM Alarm Browser.
SNMP Drivers
• [Ref. #25459] iControl now supports the Motorola SE-6000-series encoders.
Densité Services
• [Ref. #29942] HMP-1801: iControl now allows you to select a serial protocol (either Oxtel or
VDCP) on the control panel of firmware version 5.1.0 or later of the HMP-1801 Densité card.
•
[Ref. #32344] HDA-193N-D-3SRP-F: iControl introduces the new REAR module
HDA-193N-D-3SRP-F in support of the HDA-1931 and HDA-1911 Densité cards.
See also
For more information about alarms for the health monitoring of Application Servers, see the
“Alarms in iControl” chapter of the iControl Version 4.11 User Guide.
See also
For more information, see the “Customizing the Dimensions of the Total FullScreen Mode”
section in the “Creating iControl Web Sites and Pages” chapter of the iControl Version 4.11
User Guide.
IMPORTANT: If your HMP-1801 card is not running firmware version 5.1.0 or later, the
Protocol tab will not be available.
See also
For more information, see the HMP-1801 High Definition Media Player Guide to Installation
and Operation (M864-9900-108).