Stereo System User Manual
7 - 8 DSP96002 USER’S MANUAL MOTOROLA
—
T
–
T Pin Activity for Current Bus Cycle Latched for
PE XE YE P Space X Space Y Space P Space X Space Y Space
0 0 0 Deasserted Deasserted Deasserted No No No
0 0 1 Deasserted Deasserted Active No No Yes
0 1 0 Deasserted Active Deasserted No Yes No
0 1 1 Deasserted Active Active No Yes Yes
1 0 0 Active Deasserted Deasserted Yes No No
1 0 1 Active Deasserted Active Yes No Yes
1 1 0 Active Active Deasserted Yes Yes No
1 1 1 Active Active Active Yes Yes Yes
Figure 7-5. Memory Space Enables Encoding
7.2.2.2 Refresh Faults
There is no internal support for refresh timers, refresh address counters or refresh faults which should deas-
sert
—
T
–
T. The page circuit assumes that refresh does not exist and therefore
—
T
–
T must be interpreted
by the external memory controller based on its knowledge of refresh timing and external bus activity. The
use of multiple processors with the same external DRAM/VRAM indicates that the memory controller is the
best place to enforce refresh priorities. With the variety of refresh techniques based on the expected mem-
ory activity, the external memory controller state machine is the best place to have global control over re-
fresh timing and arbitration caused by multiple access conflicts. At the end of each external bus cycle, the
external memory controller should determine if it should begin a refresh cycle. If yes, it will disable the trans-
fer acknowledge
—
T
–
A signal to ensure that the DSP96002 waits if it begins an external access. Once the
refresh is completed, the external memory controller must remember to ignore the
—
T
–
T signal for the next
memory cycle so that a fast access mode is not used. The external state machine should cancel (ignores)
the effect of the
—
T
–
T signal in the next external bus cycle after any hardware refresh operation. Note that
if fast interrupts are used to implement a software refresh, refresh looks like a memory read cycle so no
special treatment of
—
T
–
T is needed.
7.2.2.3
—
R
—
A
–
S,
—
C
—
A
–
S and SC Timeout Faults
Since DRAM/VRAM devices are dynamic, there are maximum limits on the
—
R
—
A
–
S and
—
C
—
A
–
S low
time which must be observed. To effectively use the fast access modes with the DSP96002, the external
state machine must keep
—
R
—
A
–
S asserted between bus cycles for page, nibble and static column
modes.
—
C
—
A
–
S must remain asserted between bus cycles for static column mode only. However, if no
external access occurs after the external state machine is ready for a fast access mode, there is a possibility
that
—
R
—
A
–
S or
—
C
—
A
–
S may "timeout". This is because the idle memory state must be "
—
R
—
A
–
S ac-
tive" to use the fast access modes with the DSP96002 non-burst, random address bus cycles. The
DSP96002 does not provide any internal support for
—
R
—
A
–
S or
—
C
—
A
–
S timeouts. The external state