Stereo System User Manual

A - 176 DSP96002 USER’S MANUAL MOTOROLA
FTRAPcc Conditional Software Interrupt FTRAPcc
Operation:
If cc, then begin software exception processing.
Assembler Syntax:
FTRAPcc
Description:
If the specified floating-point condition is true, normal instruction execution is suspended and software ex-
ception processing is initiated. The interrupt priority level (I1,I0) is set to 3 in the status register if a long
interrupt service routine is used. If the specified condition is false, continue with the next instruction. See
Section A.10 for restrictions. Non-aware floating-point conditions set the SIOP flag in the IER register and
the UNCC bit in the ER register if the NAN bit is set. This action occurs before stacking the status register
when the specified non-aware floating-point condition is true.
"cc" may specify the following conditions:
Non-aware
Mnemonic Condition Set UNCC*
EQ - equal Z = 1 No
ERR - error UNCC v SNAN v OPERR v No
OVF v UNF v DZ = 1
GE - greater than or equal NAN v (N & ~Z) = 0 Yes
GL - greater or less than NAN v Z = 0 Yes
GLE - greater, less or equal NAN = 0 Yes
GT - greater than NAN v Z v N = 0 Yes
INF - infinity I = 1 Yes
LE - less than or equal NAN v ~(N v Z) = 0 Yes
LT - less than NAN v Z v ~N = 0 Yes
MI - minus N = 1 No
NE(Q) - not equal Z = 0 No
NGE - not(greater than or equal)NAN v (N & ~Z) = 1 Yes
NGL - not(greater or less than) NAN v Z = 1 Yes
NGLE - not(greater, less or equal)NAN = 1 Yes
NGT - not greater than NAN v Z v N = 1 Yes
NINF - not infinity I = 0 Yes
NLE - not(less than or equal) NAN v ~(N v Z) = 1 Yes
NLT - not less than NAN v Z v ~N = 1 Yes
OR - ordered NAN = 0 No
PL - plus N = 0 No
UN - unordered NAN = 1 No
Note: The operands for the ERR condition are taken from the ER register.
* See the description of the UNcc bit in Section A.4.
CCR Condition Codes: Not affected.
ER Status Bits: