Stereo System User Manual

2 - 16 DSP96002 USER’S MANUAL MOTOROLA
4.11.2 The Arbitration Protocol
The bus is arbitrated by a central bus arbitrator, using individual request/grant lines to each bus master.
The arbitration protocol can operate in parallel with bus transfer activity so that the bus hand-over can be
made without much performance penalty.
The arbitration sequence occurs as follows:
5:12. All candidates for bus ownership assert their respective
—
B
–
R signals as soon as they need
the bus.
5:13. The arbitration logic designates a bus master-elect by asserting the
—
B
–
G signal for that de-
vice.
5:14. The master-elect tests
—
B
–
B to ensure that the previous master has relinquished the bus.
If
—
B
–
B is deasserted, then the master-elect asserts
—
B
–
A, which designates the device as
the new bus master. If a higher priority bus request occurs before the
—
B
–
B signal was
deasserted, then the arbitration logic may replace the current master-elect with the higher
priority candidate. However, only one
—
B
–
G signal must be asserted at one time.
5:15. The new bus master begins its bus transfers after the assertion of
—
B
–
A.
5:16. The arbitration logic signals the current bus master to relinquish the bus by deasserting
—
B
–
G at any time. A DSP96002 bus master releases its ownership (deasserts
—
B
–
A) after
completing the current external bus access. If an instruction is executing a Read-Modify-
Write external access, a DSP96002 master asserts the
—
B
–
L signal and will only relinquish
the bus (and deassert
—
B
–
L) after completing the entire Read-Modify-Write sequence.
When the current bus master deasserts
—
B
–
A, the
—
B
–
B signal must also be deasserted
because the next bus master-elect has received its
—
B
–
G signal and is waiting for
—
B
–
B to
be deasserted before claiming ownership.
The DSP96002 has 2 control bits and one status bit, located in the Bus Control Registers (see Section 7)
to permit software control of the
—
B
–
R and
—
B
–
L signals, and to verify when the chip is the bus master.
If the RH bit in the BCR register is cleared, the DSP96002 asserts its
—
B
–
R signal only as long as requests
for bus transfers are pending or being attempted. If the RH bit is set,
—
B
–
R will remain asserted. If the
LH bit in the BCR register is cleared, the DSP96002 asserts its
—
B
–
L signal only during a read-modify-
write bus access. If the LH bit is set,
—
B
–
L will remain asserted.
5.16.1 Arbitration Scheme
The bus arbitration scheme is implementation dependent. The diagram in Figure 2-7 illustrates a common
method of implementing the bus arbitration scheme. The arbitration logic determines the device priorities
and assigns bus ownership depending on those priorities.