User`s guide

Target Settings
DSP56800E-Specific Target Settings Panels
67Targeting MC56F83xx/DSP5685x Controllers
M56800E Target (Debugging)
Use the debugging M56800E Target panel (Figure 4.13) to set parameters for
communication between a DSP56800E board or Simulator and the CodeWarrior
DSP56800E debugger. Table 4.12
explains the elements of this panel.
NOTE
Communications specifications also involve settings of the Remote
Debugging panel (Figure 4.11, Figure 4.12).
Auto-clear previous breakpoint on new breakpoint
request
This option is only available when you enable the Use hardware breakpoints option.
When you also enable the
Auto-clear previous hardware breakpoint and set a
breakpoint, the original breakpoint is automatically cleared and the new breakpoint is
immediately set. If you disable the
Auto-clear previous hardware breakpoint option
and attempt to set another breakpoint, you will be prompted the following message:
Table 4.12 Remote Debugging Panel Elements
Element Purpose Comments
Connection list
box
Specifies the connection type:
• 56800E Simulator — appropriate
for testing code on the simulator
before downloading code to an
actual board.
• 56800E Local Hardware
Connection (CSS) — appropriate
for using your computer’s
command converter server,
connected to a DSP56800E board.
Selecting 56800E Simulator keeps
the panel as Figure 4.11
shows.
Selecting Local Hardware
Connection adds the JTAG Clock
Speed text box to the panel, as
Figure 4.12
shows.
Remote
Download Path
text box
Not supported at this time.
Launch Remote
Host Application
checkbox
Not supported at this time.
JTAG Clock
Speed text box
Specifies the JTAG lock speed for local
hardware connection. (Default is 8000
kilohertz.)
This list box is available only if the
Connection list box specifies Local
Hardware Connection (CSS).