User`s guide

Debugging for DSP56800E
EOnCE Debugger Features
204
Targeting MC56F83xx/DSP5685x Controllers
Browse Button
Clicking the Browse button displays OPENFILENAME or SAVEFILENAME,
depending on whether you selected the
Restore Registers or Save Registers radio
button.
EOnCE Debugger Features
The following EOnCE Debugger features are discussed in this section:
• Set Hardware Breakpoint Panel
• Special Counters
• Trace Buffer
• Set Trigger Panel
NOTE These features are only available when debugging with a hardware
target.
For more information on the debugging capabilities of the EOnCE, see the EOnCE
chapter of your processor’s user manual.
Set Hardware Breakpoint Panel
The Set Hardware BreakPoint panel (Figure 8.9) lets you set a trigger to do one of the
following: halt the processor, cause an interrupt, or start or stop trace buffer capture.
To open this panel:
1. From the menu bar, select DSP56800E > Set Breakpoint Trigger(s).
To clear triggers set with this panel:
1. From the menu bar, select DSP56800E > Clear Triggers.