User`s guide

Debugging for DSP56800E
Load/Save Memory
197Targeting MC56F83xx/DSP5685x Controllers
6. Click the OK button.
To Change an Existing Remote Connection
To change an existing remote connection:
Double click on the connection name that you want to change, or click once on
the connection name and click the
Change button (shown in Figure 8.4 in grey).
To Remove an Existing Remote Connection
To remove an existing remote connection:
Click once on the connection name and click the
Remove button (shown in Figure
8.4 in grey).
Debugging a Remote Target Board
For debugging a target board connected to a remote machine with Code Warrior IDE
installed, perform the following steps:
1. Connect the target board to the remote machine.
2. Launch the command converter server (CCS) on the remote machine with the
local settings configuration using instructions described in the section “Essential
Target Settings for Command Converter Server”.
3. In the Target Settings>Remote Debugging panel for your project, make sure the
proper remote connection is selected.
4. Launch the debugger.
Load/Save Memory
From the menu bar of the Metrowerks CodeWarrior window, select Debug > Load/
Save Memory
to display the Load/Save Memory dialog box (Figure 8.6).