User`s manual

M9328MX1ADS - Rev 2 User’s Manual
42 Support Information MOTOROLA
Support Information
* Passive/Active LCD matrix functions, signal function depends on the LCD
type configuration selected.
3.10 SIM Card Connector
Connector P3 is the MX1ADS SIM card connector. Figure 3-9
gives the pin assignments and Table 3-9 gives the signal
descriptions for this connector.
Figure 3-9 SIM Card Connector P3 Pin Assignments
23 PS Control signal output for source driver (Sharp panel dedicated signal)
24 CLS Start signal output for gate driver. This signal is inverted version of PS
(Sharp panel dedicated signal)
31 TOP Negative pen-Y analog input
32 BOTTOM Positive pen-Y analog input
33 LEFT Negative pen-X analog input
34 RIGHT Positive pen-X analog input
Table 3-8 LCD Panel Connector P8 Signal Descriptions (Continued)
Pin Mnemonic Signal
PUSH OPEN
1
2
34
5
6
Table 3-9 SIM Card Connector P3 Signal Descriptions
Pin Mnemonic Signal
1 SIM_TX/SIM_RX SIM TRANSMITTED/ SIM RECEIVED DATA - SIM card data, tied
together externally through zero ohm resistor.l
2, 4 VCC VCC (3.0-volts) SIM card power
3 GND GROUND
5 SIM_RST SIM RESET - Active low output to SIM card
6 SIM_CLK SIMCLOCK - output clock to SIM card