User`s manual

M9328MX1ADS - Rev 2 User’s Manual
40 Support Information MOTOROLA
Support Information
3.9 LCD Panel Connector
Connector P8 is the MX1ADS LCD panel connectors. Figure 3-8
gives the pin assignments and Table 3-8 gives the signal
descriptions this connector.
16 ~ECB END CURRENT BURST — Active-low input signal asserted by external
burst devices; indicates the end of a burst sequence.
17 TMS TEST MODE SELECT – Output signal that sequences the target’s
JTAG state machine, sampled on the rising edge of the TCK signal.
18 ~LBA LOAD BURST ADDRESS — Active-low signal asserted during burst
mode accesses; causes the external burst device to load a new starting
burst address.
19 TDI TEST DATA INPUT — Serial data output line, sampled on the rising
edge of the TCK signal.
20 ~BCLK BURST CLOCK — Output signal to external burst devices;
synchronizes burst loading and incrementing.
21 ~TRST TARGET RESET — Active-low output signal that resets the target.
22 ~BAA BURST ADDRESS ADVANCE — Active-low signal asserted during
burst mode accesses; causes the external burst devices to increment
internal burst counters.
Table 3-7 MultiTrace Connector P27 Signal Descriptions (Continued)
Pin Mnemonic Signal