User`s manual

Configuration and Operation
Add On Module Connections and Usage
User’s Manual M9328MX1ADS - Rev 2
MOTOROLA Configuration and Operation 27
2.5.4 Using the BlueTooth Daughter Board
This connector, P9, comes configured to operate directly with the Motorola
MMM7400 Bluetooth RF module that is included in the M9328MX1ESBP.
There are zero ohm resistor components that may be removed and/or added to
change what signals are connected. This can be used to adapt the connector to
other RF modules from other vendors. Software to control this interface using
the MMM7400 may be found at the following web site:
http://www.motorola.com/dragonball
Warning: To avoid circuit damage, do not plug in a Bluetooth module with
power applied to the board.
2.5.5 Using the Image Sensor daughter boards
This connector comes configured to operate directly with the CSI Daughter
Card that is included in the M9328MX1ESBP. The communication with this
card takes place through the I
2
C interface. Refer to the specification for the
SMC20014 included on the user documentation CD for information on how to
use this device.
To install the image sensor boards, first locate the TetraCam sensor board. Plug
its J1 connector into the J1 connector of the CSI Daughter Card. Make sure that
JP1 has a jumper installed and that JP2 does not. Plug the 48 position DIN
connect on the back side of the CSI daughter card into P20 of the main board.
The two boards will be at a right angle to each other with the image sensor
facing away from the main board.
Warning: To avoid circuit damage, do not plug in the TetraCam Image
Sensor or CSI daughter card with power applied to the board.