User`s manual

Configuration and Operation
Add On Module Connections and Usage
User’s Manual M9328MX1ADS - Rev 2
MOTOROLA Configuration and Operation 25
* For information on ARM supplied devices that are compatible with these
connectors please visit ARM’s web site at: http://www.arm.com
2.5 Add On Module Connections and Usage
2.5.1 Using the TFT LCD Display Panel
Your MX1ADS and MX1ESBP come equipped with a touch control enabled
TFT (Thin Film Transistor) LCD display assembly. The TFT LCD component
is from Sharp Corporation, model number LQ035Q2DD54. A detailed
specification has been included on the documentation CD that came with your
ADS.
P10 USB Standard USB connector.
P11 UART1 Standard DB9 connector set up for DCE operation.
P12 UART2 Standard DB9 connector set up for DCE operation.
P14 Voice Out Standard 3.5 mm connector for stereo audio.This is the
output of the amplified voice out from the MC9328MX1
suitable for use with standard headphones with a 16 to 32
ohms impedance.
P15 Microphone Standard 3.5 mm connector for stereo audio. Use only
dynamic microphones with a 200 to 600 ohms impedance.
P19 Expansion Standard 48 pin, three row, male DIN connectors. Can
connect directly or be cabled to a custom circuit board.
P20 Image sensor Connect image-sensor daughter board to this connector,
then connect ribbon cable and lens board to the daughter
board.
P23 Power Plug the 3-volt power-supply jack end into this connector.
P24 MultiICE Standard ARM MultiICE connector.*
P26 Headphone Standard 3.5 mm connector for stereo audio. This is the
amplified stereo output of the
DAC3550A. Use
headphones with a 16 to 32 ohms impedance.
P27 MultiTrace Standard ARM MultiTrace connector.*
Table 2-13 MX1ADS Connectors (Continued)
Connector Purpose Comments