User`s manual

M9328MX1ADS - Rev 2 User’s Manual
24 Configuration and Operation MOTOROLA
Configuration and Operation
2.4 Using The Board Connectors
Table 2-13 lists the MX1ADS connectors, explaining their function, and any
special instructions for using the connector. Figure 1-1 shows the connector
locations on the board along with their reference designators.
Table 2-13 MX1ADS Connectors
Connector Purpose Comments
J1 Ethernet Standard Ethernet connector. A cable for direct network and
one for crossover connections (direct to a PC) have been
provided in the m9328MX1ESBP Professional Edition.
J2 SODIMM Slide SODIMM card into the connector until it snaps into
place. Not compatible with off the shelf DIMM modules.
JP3 FOUTR, FOUTL Filtered output of right and left channels from the
DAC3550A.
JP4 AUX1R, AUX1L, Auxiliary audio input channel 1 with left and right stereo
inputs. Compatible with low level outputs of most audio
electronics.
JP5 AUX2R, AUX2L Auxiliary audio input channel 2 with left and right stereo
inputs. Compatible with low level outputs of most audio
electronics.
P2 SD/MMC Connector is on bottom of board, directly below the P5
memory stick connector. Slide the MMC unit into the
connector until it snaps into place. Shares signals with the
Memory Stick card interface.
P3 SIM Unsnap latch, swing lid up. Slide SIM card inside, matching
alignment of contacts at the connector base. Close the lid
and push down to latch.
P5 Memory Stick Slide the memory stick into the connector until it snaps into
place. Shares signals with the SD/MMC card interface.
P8 LCD panel Connect LCD ribbon cable between this connector and the
corresponding connector of the LCD display panel, J11.
P9 BlueTooth module Connect a compatible Bluetooth daughter board into this
connector. A MMM7400 Bluetooth module is included in the
M9328MX1ESBP kit.