User`s manual

General Information
System and User Requirements
User’s Manual M9328MX1ADS - Rev 2
MOTOROLA General Information 5
• PC compatible RS232 serial cable.
• Metrowerks CodeWarrior IDE software (evaluation copy).
1.3 System and User Requirements
To use an M9328MX1ADS Application Development System, you need:
• An IBM PC or compatible computer that has:
– a Windows 98, Windows ME, Windows XP, Windows 2000,
or Windows NT (version 4.0) operating system.
– a parallel port if you are using a MultiICE device
or
– an RS-232 serial port, capable of operation at 9600 to 115200 bits per
second operation, if you are using MetroTRK.
•A + 3.0-volt-to +3.3-volt power supply, at 1500mA, with a 2mm female
(inside positive) power connector (included).
• An RS-232 cable (DB9 male-female, included) for connecting to the
internal UART while using bootstrap mode or Metrowerks’ MetroTRK.
• Hyperterminal (or a comparable terminal-emulation program) for
downloading the MetroTRK image to MX1ADS SyncFlash memory.
CAUTION: Never supply more than +3.3-volts power to your MX1ADS. Doing so could
damage board components.