User`s manual

M9328MX1ADS - Rev 2 User’s Manual
4 General Information MOTOROLA
General Information
• Two 4-megabyte × 16-bit SyncFlash memory devices, configured as one
32-bit device.
• Two 16-megabyte × 16-bit SDRAM devices, configured as one 32-bit
device.
• SODIMM connector for SDRAM or EIM memory expansion.
• Connectors for SD/MCC, MemoryStick, and SIM memory cards.
• Two UART ports, each with RS232 transceiver and DB9 connector.
• An IrDA transceiver that conforms to Specification 1.0 of the Infra-red
Data Association.
• PDIUSBP11A USB transceiver and series B USB connector
• Separate LCD panel assembly with a ribbon cable that connects to the
main board and interfaces directly with the MC9328MX1ADS.
• Bluetooth RF module connector. (The MC9328MX1ESBP includes a
Bluetooth MMM7400 card.)
• CMOS Image Sensor (CSI) Connector. (The MC9328MX1ESBP
includes a compatible image-sensing components.)
• MultiICE and MultiTrace debug support connectors.
• DAC3550A CD Quality DAC that interfaces with SSI. System support
includes two clock-source crystal oscillators and a 3.5mm
speaker/headphone jack.
• Cirrus Logic CS8900A Ethernet controller, with a RJ-45 connector for
connecting to a system hub.
• Two RJ-45 Ethernet cables, network and crossover (MC9328MX1ESBP
only).
• Microphone/voice interface amplifier circuity, with 3.5mm voice out and
microphone in jacks.
• 32 × 3-pin DIN expansion connector with most MX1 I/O signals.
• LED indicators for power, external bus activity, Bluetooth data transfer,
Ethernet activity, and two LEDs for user defined status indiction.
• Universal power supply with 3.0-volt output @1500ma.
• PC compatible USB cable.