User`s guide

26 Help
3.21.10 Setting the security code
This is used to change the remote access PIN if necessary.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
ANSWER MACHINE .
2. Press MENU and then VOL+ or REDIAL/VOL- to select
SECURITY CODE .
3. Press MENU and then enter the 4- digit security code.
4. Press MENU to save.
4. Help
The icon is not scrolling when the handset is
placed on the base
• Handset not properly seated on the base cradle -
readjust the handset on the base.
• Dirty contact - clean the charge contacts by wiping with
an alcohol moistened cloth.
• Battery is full - charging is not necessary at this time.
No dial tone
• If there is no base power, check the connections. Reset
the phone by unplugging then plugging it back into an
electrical outlet.
• If the handset batteries are empty, recharge the battery
pack for at least 24 hours.
• Move the handset closer to the base.
• Be sure to use only the provided telephone cords.
Poor audio quality
• If the base is too close to electrical appliances, reinforced
concrete walls, or metal door frames, move the base
from these areas.
Press... To...
1 Repeat the message
2 Play/Stop the current message playback
3 Skip forward to the next message
4 Toggle Answer Off/Announce Only/Announce
and Record modes
5 Delete the message
7 Listen to the Main Menu (for full voice prompts
only)
After entering the remote access mode, press the following
keys to carry out your desired function.