Cable Box User Manual

3 INSTALLATION

Operational Check for the Remote Control

The operational check tests communication with the remote control:

Table 3-1 Operational check procedures

Feature Testing Procedure

Power on

Press POWER on the remote control to turn on the DCX3200.

Tune to the output channel (3 or 4) if using the RF output.

Channel selection

Scan through the channels using the CHANNEL + or - keys.

Tune to several channels by entering the channel number using the numeric keys.

Volume control

Press VOLUME + or - on the remote control to increase the volume to its upper

limit, lowest level, and to a comfortable level.

Press MUTE to turn the sound off. Press MUTE again to restore the sound.

If the DCX3200 does not operate properly, refer to the Troubleshooting section.

Configuring the Audio, Video, and Closed Caption Settings

This subsection describes how to configure the audio (for HDMI™ connections), SD and

HD video settings, and closed caption settings for the DCX3200.

Before you adjust the output settings:

• Connect the DCX3200 to the TV and other home entertainment devices

• Plug the DCX3200 into an AC power outlet

• Initialize the DCX3200 and authorize it for services

• Turn the TV on

When using an HDMI™ connection between the DCX3200 and the television, be sure

to have the cable connected and the TV powered on before adjusting the video settings.

Motorola recommends using HDMI™ cables less than 20 meters long.

To configure the DCX3200 settings on the main User Settings menu screen:

1. Power off the DCX3200 and then immediately press the

MENU key on the remote

control. If the TV is on, the on-screen menu lists the settings you can be adjusted: