Home Theater System User Manual MODEL NO.: DCP 501

54 Operation

DCP501 User Guide

* L E F T

I G H T S E T U P *

X L E F T / R I G H T : L A R G E

D I S T A N C E : 1 0 f t

R E T U R N T O M E N U

* L E F T

I G H T S E T U P *

L E F T / R I G H T : S M A L L

X D I S T A N C E : 1 0 f t

R E T U R N T O M E N U

21 Press SELECT or OK and the currently selected setting flashes. In this example, LARGE

flashes. The

LARGE and SMALL settings determine which speakers receive low frequency

(bass) information. Use the

LARGE setting for a speaker that is a traditional full-range

speaker capable of reproducing sounds below 100Hz. Use the

SMALL setting for smaller,

frequency-limited satellite speakers that do not reproduce sounds below 100Hz. When the

SMALL setting is used, a subwoofer is required to reproduce low frequency sounds. Note

that

LARGE and SMALL refer to the speaker’s ability to reproduce low frequency sounds

and not their physical size. Consult the manufacturer’s manual that accompanied your

speakers for more information.

On-screen Display DCP501 Display

22 Press CURSOR left/right (<

< >

>) to display LARGE or SMALL.

 The speaker icon on DCP501 display changes with the

LARGE/SMALL setting.

 The settings for

LEFT/RIGHT SETUP are affected by your setting on the

SUBWOOFER SETUP

23 Press SELECT or OK to accept your selection and LARGE or SMALL stops flashing.

24 Press down arrow (∨

∨∨

∨).

On-screen Display DCP501 Display

G E

D I S T

NC E