Installation manual
Table Of Contents
- CONTENTS
- 1 INTRODUCTION
- 2 OVERVIEW
- 3 INSTALLATION
- 4 DIAGNOSTICS
- Using the Diagnostics
- General Status
- Out Of Band (OOB) Status
- Agile OOB Tuner Hunting
- In Band Status
- Audio/Video Status
- Unit Address
- Separable Security
- Firmware Version
- Current Channel Status
- Renewable Security
- Upstream Modem
- App Code Modules
- Memory Configuration
- Interactive Status
- MAC Frequency Table
- Control Channels
- Message Types
- In-band Program Association Table (PAT)
- In-band Program Map Table (PMT)
- Task Status
- In-band Multicast Address Filter
- Connected Home Status
- Keyboard / LED
- 5 TROUBLESHOOTING
4 DIAGNOSTICS
32
Interactive Status
This diagnostic tool gathers data about your system.
The Interactive Status fields are:
Field Description
IP The set-top IP address assigned by the NC 1500, in dotted-decimal format; for example
xxx.xxx.xxx.xxx where each xxx ranges from 000 to 255. 0.0.0.0 is displayed if the IP
address is not configured or unknown.
UPM The upstream modem address. This UPM value is the same as the terminal ID assigned by
the DAC 6000. It is a unique, system-generated, eight-digit integer between 1 and
16777215. 00000000 is displayed when the UPM is not configured or unknown.
Upstream ID The set-top transmission parameter assigned by the DAC 6000. It is a four-digit decimal
value from 0000 to 9999. 0000 is displayed if the Upstream ID is not configured or
unknown.
Downstream
ID
The set-top transmission parameter assigned by the DAC 6000. It is a four-digit decimal
value from 0000 to 9999. 0000 is displayed if the Downstream ID is not configured or
unknown.
State The interactive status of the set-top:
OSD Description
UNCONFIG The set-top is not configured for the interactive system, and
the platform should run as pre-interactive.
MAC_CONNECT The set-top is waiting to establish a connection to the MAC
PID Stream.
INIT_WAIT_DC_OR_C The set-top is in the interactive initialization state and waiting
for the default configuration or the contention channel list
messages.
WAIT_LM_ACK The set-top is in the interactive initialization state and waiting
for Link Management Response ACK for Local Address
Message.