Installation manual
Table Of Contents
- CONTENTS
- 1 INTRODUCTION
- 2 OVERVIEW
- 3 INSTALLATION
- 4 DIAGNOSTICS
- Using the Diagnostics
- General Status
- Out Of Band (OOB) Status
- Agile OOB Tuner Hunting
- In Band Status
- Audio/Video Status
- Unit Address
- Separable Security
- Firmware Version
- Current Channel Status
- Renewable Security
- Upstream Modem
- App Code Modules
- Memory Configuration
- Interactive Status
- MAC Frequency Table
- Control Channels
- Message Types
- In-band Program Association Table (PAT)
- In-band Program Map Table (PMT)
- Task Status
- In-band Multicast Address Filter
- Connected Home Status
- Keyboard / LED
- 5 TROUBLESHOOTING
4 DIAGNOSTICS
25
Field Description
set to ‘Unknown’ if the headend message was not received
MSO Phone Number MSO Phone Number, as configured at the headend
CableCARD
Object Name Code object name executing on the CableCARD
Object Ver. Code object version executing on the CableCARD
Manufacturer CableCARD manufacturer
HW Version Version number provided by the CableCARD.
Boot Version The version number provided by the CableCARD.
2
nd
Version The version number of the second stored object provided by the
CableCARD.
Firmware Version
This diagnostic displays the following:
Field Description
Dena firmware version
or revision number
Firmware version number currently executing on the set-top
Build date and time Build data and time of the Dena firmware version
BOOT Lowest firmware code level that can be used on this set-top
TSODA firmware
version number
Firmware version number of the TSODA
CAMEL (CMLBK)
firmware version
number
Always 0000
FPGA
Controls the CableCARD, the MoCA chip, and the Security Processor chip