Installation manual

4 DIAGNOSTICS
42
Audio/Video Status
Audio/Video Status diagnostics display information regarding audio and video content
and settings configured for the set-top.
AUDIO SPDIF
Indicates SPDIF Mode as set by application software.
OSD Display Description
N/A Audio SPDIF mode is not applicable
IEC958PCM PCM audio selected
Dolby For Dolby Selection, the following speaker selection is set:
1/0 right front or left front
2/0 right front and left front
3/0 right front and left front and center
2/1 right front and left front and (right rear or left rear)
3/1 right front and left front and center and (right rear or left rear)
2/2 right front and left front and right rear and left rear
3/2 right front and left front and center and right rear and left rear
LFE: Low Frequency Effect
The LFE indicates if the nomenclature low frequency effects are available in
the Dolby audio stream as indicated if the “0.1” is present in the Dolby 5.1
nomenclature (for example, “Dolby 5.1 surround”). Valid values include:
OSD Display Description
0 LFE is not available
1 LFE is available (for example, “Dolby 5.1 surround”).
Muting State and Method
The Audio and Video Mute Status indicates if the audio and/or video has
been muted by the software. The audio mute is either “On” or “Off.” The
Video Mute describes the MPEG muting method selected by the software
and indicates if the output video is in the mute state by displaying “On” or
“Off,” followed by the mute method. Methods include: