Car Satellite TV System User Manual

3 INSTALLATION

Operational Check for the Remote Control

The operational check tests communication with the remote control:

Table 3-1 Operational check procedures

Feature Testing Procedure

Power on

Press POWER on the remote control to turn on the DCH3200.

Tune to the output channel (3 or 4) if using the RF output.

Channel selection

Scan through the channels using the CHANNEL + or - keys.

Tune to several channels by entering the channel number using the

numeric keys.

Volume control

Press VOLUME + or - on the remote control to increase the volume to

its upper limit, lowest level, and to a comfortable level.

Press MUTE to turn the sound off. Press MUTE again to restore the

sound.

If the DCH3200 does not operate properly, refer to the Troubleshooting section.

Optimizing the High-Definition Settings

This subsection describes how to optimize SD and HD video settings and closed

captioning based on subscriber preferences.

Before you optimize the output settings:

• Connect the DCH3200 receiver to other home entertainment devices

• Plug the DCH3200 receiver into a power outlet

• Initialize the DCH3200 receiver and authorize services

• Turn the TV on

For an HDMI connection, be sure the TV is on and connected to the HDMI connector

before adjusting the settings. Motorola recommends using HDMI cables less than 20

meters long.

To optimize the output settings:

1. Power off the DCH3200 and then immediately press the

MENU key on the front

panel. If the TV is on, the on-screen menu lists the settings you can configure: