Installation manual

4 DIAGNOSTICS
42
Field Description
Nodes The MoCA Node ID and Settop MR-DVR Node ID values of each device in the
Home Network in format MM/SS, where MM equals the decimal digit MoCA
Node ID within the range of 0-15 and SS equals the decimal digit Settop MR-
DVR Node ID within the range 1-8. Displays a single dash “-“ for the device if
this information is not available.
Displays an asterisk “*” in the row of the device that is the Local Device
displaying diagnostics.
Displays an “N” in the row for the device that is the Network Coordinator for the
Home Network. Displays an “M” in the row of the device that is the MR-DVR
Set-top Master device
Displays “da” in the row of any device that is in the Home Network but is de-
authorized for MR-DVR services
Displays “inact” in the row of any device that is inactive in the MR-DVR network
Dev Displays the device type of the device:listed:
• NIM
• EHub
• ETerm Hub
• Term
• N/A
#Ses The total number of MR-DVR playback and record sessions currently being
supported by the device listed
Ver Displays the software version of the Entropic chipset in xx.yy format of the
device listed
Mac The MAC address of the device listed in 8-byte colon-hex format
(xx:xx:xx:xx:xx:xx:xx:xx)
IP The IP address of the device listed in 4-byte dotted decimal format
(xxx.xxx.xxx.xxx).Displays “0.0.0.0” if the IP address of the device is not
configured or unknown.
Connected
Home Link
Status Table
The Connected Home Link Status Table contains information related to the transmit phy
rate between each device in the Home Network and may display warning indications under
fault conditions. The warning status fields are in format “aabbcc” preceding the “From
Node” row heading. These fields are blank if no fault condition exists, or display the
following under the defined conditions:
aa Displays “Bw” in the “aa” portion to indicate a minimum bandwidth available
warning
bb Displays “Fr” in the “bb” portion to indicate a packet error warning
cc Displays “Pw” in the “cc” portion to indicate a power level warning
Collecting
Data
Displays “In Progress when the set-top is in the process of collecting the required data and
populating the Connected Home Link Status Table.
Displays “Complete” when the set-top has completed collecting the required data and has
populated the Connected Home Link Status Table.
Displays “N/A” when the data it has collected is invalid or unable to retrieve the data