Specifications

DC600 Portal Integrator Guide1-4
DC600 LEDs
The DC600 includes two sets of LEDs described in Table 1-1.
DC600 Standard Edition
The Standard Edition DC600s include the following components:
• DC600 Dock Door Frame: The dock door frame provides a bolted installation and houses the XR400 reader and high
performance antennas.
• XR400 RFID Reader: Refer to the XR400 Integrator Guide.
• High Performance Antennas: The antennas connect to the reader to enable tag reading in the read range. Dual models
include four antennas, and single (left or right) models include two antennas.
• Portal and reader status LEDs.
DC600 Professional Edition
The Professional Edition DC600s include all of the components offered in the Standard Edition, as well as the motion
sensor.
Motion Sensor
The motion sensor initiates tag reads when movement is it detected. This ensures antennas only read tags when tag
movement occurs through the dock door, e.g., when pallets pass through the DC600 system.
DC600 Configurations
The DC600 is available in single (left or right) and dual configurations for monitoring different types of dock doors.
Businesses can choose between the Standard or Professional editions depending on requirements.
The DC600 offers three configurations:
• Single: Includes two high-performance antennas mounted on a single frame that installs on the side of a dock door. This is
usually mounted as a paired system with another single or another dual.
• Dual: Includes four high-performance antennas mounted on a single frame that installs between two dock doors. This is
usually mounted as a paired system with one or two singles.
• Slim Single: Includes two high-performance antennas mounted on a single compact frame that installs against a wall. This
is usually mounted as a paired system with another single model or a single and dual model.
See Figure 1-1 on page 1-3 for DC600 model illustrations.
Table 1-1. DC600 LED Indications
LED Indication
Portal Status LEDs (located on side of DC600, near the top, non-programmable)
Green DC600 is powered on.
Red Hardware fault.
Reader Status LEDs (located on front/rear of DC600, near the top, programmable)
Red/Green/Amber All three LEDs light upon power-up.
Amber Successful tag read.
Green Reader firmware driven or programmable via XML commands.
Red Off by default, but programmable via XML commands.