Specifications

Introduction

This Integrator Guide provides information about installing and using the DC600 portal system, a fully assembled turn-key solution

that uses Radio Frequency Identification (RFID) for asset identification and tracking goods movement.

Chapter Descriptions

Topics covered in this guide are as follows:

• Chapter 1, Getting Started provides an overview of the DC600 portal system.

• Chapter 2, Installation describes how to install the DC600 hardware and components.

• Chapter 3, Motion Sensor Configuration describes how to configure the XR400 to work with the DC600 when using a motion

sensor, and how to install the antennas and group them logically using firmware to avoid deployment problems.

• Appendix A, Specifications provides technical specifications for the DC600 and motion sensor, signals, and pinouts.

• Appendix B, XML Software Commands lists the XML commands for controlling LEDs.

Notational Conventions

The following conventions are used in this document:

• Italics are used to highlight the following:

• chapters and sections in this and related documents

• dialog box, window and screen names

• drop-down list and list box names

• check box and radio button names

• icons on a screen.

• Bold text is used to highlight the following:

• key names on a keypad

• button names on a screen.

• Bullets (•) indicate:

• action items

• lists of alternatives

• lists of required steps that are not necessarily sequential.

• Sequential lists (e.g., those that describe step-by-step procedures) appear as numbered lists.