User guide

31
4Tutorial
WRITING THE CODEPLUG TO THE PHONE
This task is synonymous with “writing entire codeplug” to the phone. A codeplug read
from one phone can only be written to that same phone using this process.
1 Set up the programming hardware as described in “Section 2: Setting Up the
Hardware” section on page 11.
2 If multiple codeplugs are open in the CPS, make the correct source codeplug file
active by clicking on its title bar.
3 Select File/Write Phone. A progress bar will be displayed. After a few seconds, it
should begin progressing toward 100%.
Remember to save the original
codeplug data before you make
any changes, so that you can
restore the phone to its original
state if the programming goes
wrong.
Never disconnect the
programming cable from the
phone during the programming
process or power off the PC
while the codeplug file is in
memory. This will cause
damage to the radio.
Note: If the progress bar does not appear or
an error occurs, go through the checklist in
the “Unable to Copy Phone” topic in the on-
line help.