User guide

42 Help
The icon is blinking
• Handset is not registered to the base – register the
handset to the base
• You are too far from the base – move closer to the base
• Switch OFF the Eco mode.
No ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller Line Identification (CLI) service
does not work
Check your subscription with your network operator
Phonebook
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory
Display
No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base power supply.
• If LED is not lit up, then try disconnecting and connecting
the base power supply.
Registration
Unable to register another handset
• Maximum number of 5 handsets has been reached.
• The display shows
SEARCHING . You must unregister a
handset in order to register a new one.
Handset display shows
NOT REG
• Please refer to page 32 of the user guide to re-register
your handset to the base.
Interference
Noise interference on your radio or television
Your base or charger may be too close. Move it as far away
as possible.
Answer machine
Answer machine does not record messages
• Switch the answer machine on.
• The memory may be full. If so, you will need to delete
some messages.
• Answer mode may be set to
ANSWER ONLY .
Change the mode to
ANSWER & REC .
Cannot access messages remotely
• Remote access may be switched off.
• If wrong PIN is entered a beep is played. You can enter
the PIN once again.