Answering Machine User Manual

Advanced settings 23
NOTE
If you switch Easy call on,
EASY CALL ON will be displayed on your screen
in standby mode.
To switch Easy call off again:
1. Press >.
2. OFF? is displayed. Press m to confirm.
Set the easy call number
1. Press m, scroll d to ADVANCED SET and press m.
2. Scroll d to EASY CALL . Press m.
3. Enter the master PIN (Default setting 0000) and press m.
4. Scroll d to NUMBER . Press m.
5. Enter the number. Press m to confirm
6. Press > to return to standby.
Dial an easy number
When an easy call number has been stored and the easy call setting
switched on, press any key (apart from
>), to dial a number.
NOTE
When easy call is switched on, you can still answer any incoming call as
normal.
Registration
Up to 5 handsets can be registered to one base station. Additional
handsets must be registered to the base before you can use them.
• The instructions described below apply specifically to your D1011
handset. If you wish to register another manufacturer’s handset, the
instructions may vary. In this case, please refer to the manufacturer of
the additional handset.
• The Master PIN is required before you can register or unregister
handsets. The default PIN is
0000 .
Register a handset
At the base:
1. Press and hold the p button on the base station for at least 3
seconds. The base station emits a beep when it is ready to accept
registration. You have 90 seconds in which to register a handset.
At the handset:
1. Press m and scroll d to ADVANCED SET and press m.
2. Scroll d to REGISTRATION and press m.
3. If necessary, scroll u or d to display REGIST. BASE and press m.
BASE 1 2 3 4 is displayed and the registered base number is flashing.
Enter the number of the base on which you wish to register your
handset.
If you have only 1 base station, press
1. If you have 2 base stations,
press
1 or 2, etc.
4. When the display shows PIN ----, enter the base PIN.
- When the handset registers with the base, it is assigned a handset
number.
Select a base
You can register your D1011 handset with up to 4 bases. Once
registered, you can switch between bases, for example, bases at home
and at work.
1. Press m and scroll d to ADVANCED SET and press m.
2. Scroll d to REGISTRATION and press m.
3. SELECT BASE is displayed. Press m.
- The available bases are displayed with the current base number
flashing.
4. Enter the number of the base you want – 1,2,3 or 4 and press m.
- When the base is found you hear a beep. If not found, the display
shows
UNREGISTERED .
Unregister a handset
1. Press m and scroll d to ADVANCED SET and press m.
2. Scroll d to UNREGISTER and press m.