User Manual
Table Of Contents
- Warranty
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Power Supply
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Waste Electrical and Electronic Equipment (WEEE)
Quick Reference Guide 7
5. Scan Numeric Bar Codes on page 8
corresponding to the passkey, then scan Enter
on page 9.
The Bluetooth button blinks slowly to indicate that
the scanner paired with the host.
Unpairing
To unpair the scanner and host, press the
Bluetooth button. Upon unpairing, the Bluetooth
button stops blinking.
Note Bluetooth pairing suspends
temporarily while charging via a
USB cable. Disconnecting the cable
re-establishes the Bluetooth pairing.
Note To enter batch scanning mode, the
scanner cannot be paired to a
Bluetooth host (applies to CS3070
model only).